Message; Specifications; Ratings; Input/Output - Tascam DR-10SG Manual Del Usuario

Message

The following is a list of the pop-up messages that might appear on the DR-10SG
under certain conditions.
Message Meaning and response
Battery Empty The battery is almost out of power. Replace the batteries.
The microSD card could not be recognized properly. Change
Card Error
the microSD card.
The microSD card has no remaining capacity. Erase unnec-
Card Full
essary files or move them to a computer to make open space.
The total number of recording files exceeds the limit of 999.
File Full Erase unnecessary files or move them to a computer to make
open space.
The microSD card is not formatted properly or the formatting
Format Error
is broken. Use the DR-10SG to format the microSD card.
Invalid Card The card might be abnormal. Change the microSD card.
No Music File There is no file that can be played back on the microSD card.
Non-Supported The file format is not a supported or the file is broken.
Writing to the microSD card timed out.
Write Timeout
Change to a card with faster writing, or backup files on the
card to a computer and format the card.
If any of these errors occurs, turn the unit off and restart it.
Player Error
If the power cannot be turned off, remove the battery or
disconnect the USB cable if using USB bus power.
If these error messages continue to appear frequently, please
Write Failed
contact a TEAC Repair Center (see back cover).
18
TASCAM DR-10SG

Specifications

Ratings

8 Recording media
microSD card (64 MB−2 GB)
microSDHC card (4 GB−32 GB)
8 Recording/playback formats
44.1/48kHz, 16/24-bit
MONO/POLY WAV (BWF format)

Input/output

8 Mic input
Directional: Supercardioid
Mic gain: 0 to +50 dB (1dB steps)
1,000Hz
330
300
270
240
210
0
°
5
30
dB
0
- 5
60
- 10
- 15
- 20 90
120
150
180