SEVERIN KS-9853 Instrucciones De Uso página 20

replace them in the corresponding
openings on the opposite side.
 Unscrew and remove the hinge pin (2)
together with the nut (1) and washers (3)
from the upper hinge bracket and replace
the entire assembly on the other side of
the unit.
 Remove the covering cap (21) from the
refrigerator door (4) and the cap (19)
from the freezer door (9) and replace
them on the other side of the door.
 Fit the refrigerator door (4) onto the
upper hinge pin (2).
 Fit the upper hinge pin of the centre
hinge bracket (6) into the bottom part of
the refrigerator door (4). Fit the centre
bracket (6) together with the plastic plate
(5) to the housing, using the screws (7) to
secure the assembly.
 Fit the freezer door (9) up onto the lower
hinge pin of the centre bracket (6).
 Fit the pin of the lower hinge bracket (13)
into the bottom part of the freezer door
(9). Fit the lower hinge bracket (13) and
the plastic plate (10), using the screws to
secure the assembly, together with the
covering panel holder (14), reversed
through 180°.
 Replace the covering panel (15) below the
freezer door (9).
Changing the door handles
 Remove the covering cap (17), take out the screws and take off the handles (18).
 Remove the covering cap from the opposite side and replace the handles in their new position.
 Replace the covering caps in the old screw holes.
If the unit has been tilted to more than 30°, wait for about 4 hours before re-connecting it to the
mains.
Temperature control
The unit is re-activated by connecting it to the mains. It is only switched off completely when the
plug is removed from the wall socket.
The green mains indicator light shows that the unit is connected to the mains.
The temperature in the refrigerator cabinet can be adjusted by setting the temperature control.
Turning the control clockwise will decrease the temperature, while turning it anti-clockwise will
increase it.
The medium settings are usually most suitable for home use.
We recommend using a thermometer to check the actual temperature inside the cabinet and make
adjustments as necessary.
20