Panasonic EYFLA4A Manual De Instrucciones página 24

Confirm the set statuses of torque,
EN
snug point determining level, buzzer,
and undetect time setting
Press button A.
The set statuses of torque, snug point
determining level, buzzer, and power-off time
setting (without detection) are displayed in
sequence.
For example, when the torque is 30, the snug
point determining level is L1, the buzzer
green indicator is lit and the buzz is heard,
and the undetect time is set to 1 second, the
display is as follows:
"30" → "L1"→ "b1" → "10"
Check the statuses of LED light and
fault detection during running, as
well as the setting of speed control
Press button B.
The set statuses of LED light, tightening time,
and speed control setting are displayed in
sequence.
For example, when the LED light mode is set
to d1, the tightening time is set to 20, and the
speed control is set to "ON", the display is as
follows:
"d1" → "20" → P0
Confirm the set statuses of main unit
ID, tilt tightening reduction, repeat
tightening prevention, and impact
speed setting corresponding to
length of socket used
Press button D.
The set statuses of main unit ID, tilt tightening
reduction, repeat tightening prevention, and
impact speed setting corresponding to length
of socket used are displayed in sequence.
For example, when the tilt tightening reduction
feature is enabled, the repeat tightening
prevention is set to 0.5 seconds, and the
impact speed corresponding to length of
socket used is set to h1, the display is as
follows:
"H9" → "R1" → "U2"→ "h1"
Display
H7
H8
H9
H0
Tool circuit
EYFLA7
EYFLA8
EYFLA9
EYFMA2
- 24 -
NOTE:
When the tool is set remotely, the signal
generated from another tool nearby may
be received by accident.
To prevent such cases, set the tool in
another room if possible, or keep a distance
from other tools.
Confirm the set status of tightening
time reminder
Press button C.
The set value of tightening time and the current
tightening time are displayed in sequence.
For example, "50" → "35"