Operation Test; Drainage Way - HJM ACP9000 Instrucciones De Uso

Inglés_Maquetación 1 25/11/15 09:55 Página 75
Disassemble heat discharge pipe
1. Remove joint B:
remove joint B from joint C.
2. Remove joint A:
Press the clasp and lift joint A
upwards to remove it.

OPERATION TEST

Put through the power supply and then press ON/OFF button on
●
remote controller to start the unit.
Press mode button to select auto, cooling, drying, fan or heating
●
function, and then check if the unit operates normally.
If ambient temperature is below 16℃, the unit can't operate in coo-
●
ling mode.

DRAINAGE WAY

In cooling or drying operation, the condensation water will be drai-
●
ned to the chassis and spattered by water-striking motor. As the
temperature of condenser is high, most of the condensation water
will be evaporated and drained to outdoor. So usually, only a little
condensation water will be accumulated inside the chassis and you
do not need to discharge the water frequently.
- 75 -
E
N
G
L
I
S
H