Telephone Helpline: 0845 146 2887
Installation
Note: If the appliance has not been stored or moved in an upright position, let it stand
upright for approximately 12 hours before operation. If in doubt allow the appliance to
stand.
Remove the appliance from the packaging and remove the protective film from all surfaces.
1.
When positioning the appliance, maintain a distance of 20cm (7 inches) between the appliance and
2.
walls or other objects for ventilation. Increase this distance if the obstacle is a heat source.
If necessary, adjust the screw legs of the appliance to make it level. The efficiency of the appliance
3.
can be reduced if it is unevenly located.
Operation
Control Panel
Hand button
Making Ice
Note: Before using for the first time, clean the water tank, ice basket and ice basket
shelf. Use the first 3 ice making cycle to flush out the system. Discard the water and ice
created from the first 3 cycles.
Each time the appliance is refilled, the first ice making cycle is used to reduce the water temperature. This
results in uneven ice cube production which is perfectly normal. You may wish to discard ice created in the
first two production cycles.
Lift the access lid and fill the water tank up the level of the ice basket shelf.
1.
Connect the appliance to the power and press the START button.
2.
Press the 'HAND' button repeatedly to scroll through the ice cube sizes. Stop when the required size is
3.
illuminated.
Note: The ice making cycle takes between 6-12 minutes, depending on the size of cube
selected. Larger cubes will take longer to produce.
The appliance will run a startup routine and then begin ice production.
4.
Note: If the water level is too low, the Water Low indicator lights up and the appliance
appliance stops working. Fill the water tank and the appliance will restart automatically.
When the cubes reach the ice sensor the appliance will stop production. Production resumes once ice
5.
has been removed.
Press the STOP button at any time to halt the ice making process.
6.
Ice cube size
indicator
UK
2