Rigging; Ball Installation; Dmx-512 Control - EuroLite LED Ball IP66 24V Manual Del Usuario

If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, lamp explosion, crash etc.

RIGGING

Ball Installation

This device is constructed for a hanging installation only.
Before attaching the device, make sure that the installation area can hold a minimum point load of 10 times
the device's weight.
Caution: Please DO NOT install the LED Ball by the power cable! For hanging installation, please use only
the appropriate chains and quick links with screw caps.

DMX-512 control

The wires must not come into contact with each other, otherwise
the devices will not work at all, or will not work properly.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the device or one device with another.
Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly with
the DMX-input of the first device in the DMX-chain. If you wish to connect DMX-controllers with other XLR-
outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first device in the DMX-chain with the DMX-input of the next device. Always
connect one output with the input of the next device until all devices are connected.
Caution: At the last device, the DMX-cable has to be terminated with a terminator. Solder a 120 resistor
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last device.
11/23 00026351.DOC, Version 1.2