Additional Features - NEO STORMER QUAD Manual De Usuario

DMX Mode
Allows the unit to be controlled by any universal DMX
controller.
Set the Starting DMX Address:
The default mode for the fixture is DMX, so the first
menu item that you can edit is the starting DMX
address.
1. Press the <UP/DOWN> buttons until you reach
Address.
2. Push the <ENTER> button.
3. Use the <UP/DOWN> buttons to select a channel
from 001-512.
4. Press the <ENTER> button to confirm.
5. Press the <ESC> button to return to the main
menu.
Select the DMX Channel Mode:
1. Press the <UP/DOWN> buttons until you reach
Config.
2. Push the <ENTER> button.
3. Using the <UP/DOWN> buttons, highlight DMX
Mode, then press <ENTER>.
4. Use the <UP/DOWN> buttons to select 1, 3, 4, 7,
8, 16, or 4/8 pixel modes.
5. Press <ENTER>, and then press the <ESC> but-
ton until you reach the Address screen.
Master/Slave Mode:
1. Disconnect fixture(s) from any DMX signal
source.
2. Set each fixture to matching DMX modes.
3. Connect all fixtures together via DMX. The first
fixture in the DMX chain will be the master, followed
by the slave fixtures.
4. Connect DMX controller to the master unit for
DMX control.
Load Default Settings:
1. Press the <UP/DOWN> buttons until you reach
Load Default.
2. Push the <ENTER> button.
P. 12
Neo Stormer Quad - English version
Auto & Standalone Modes
Allows a single or Master/Slaved units to run factory
installed programs at user selectable speeds.
Auto Mode:
1. Press the <UP/DOWN> buttons until you reach
Auto.
2. Push the <ENTER> button.
3. Use the <UP/DOWN> buttons to select from
Mode 1 to Mode 6.
4. Press the <ENTER> button to confirm.
Auto Program Speed:
1. Press the <UP/DOWN> buttons until you reach
Speed.
2. Push the <ENTER> button.
3. Use the <UP/DOWN> buttons to select from
000-031.
4. Press the <ENTER> button to confirm.

Additional Features

Never thought you would ever see so many nifty
neato features in a strobe light did you?
Temperature:
IMPORTANT - Brightness will decrease when the
LED temperature rises over 55ºC. If a tempera-
ture of +70ºC is reached, the overheat protection
sensor will activate, initiating blackout until a safe
temperature is reached. It's highly recommended
to not use the LEDs at full strobe brightness for
longer than a 1 minute period. You can safely use
the fixture as a normal wash in 4/8 pixel modes
which are programmed to achieve a max of 40%
strobe brightness.
1. Press the <UP/DOWN> buttons until you reach
Temp.
2. Push the <ENTER> button.
3. The display will show the current temperature
in Celsius degrees.
Signal Loss Settings:
In the event of DMX signal loss, you can set the fix-