Orbis Athena Manual De Instrucciones página 61

• Press [OK] to modify the parameters. The modifi able parameter is the one fl ashing.
ADV
ESC ESC
• Use the and arrows to select the parameter to be modifi ed and the
arrows to modify it. Press [OK] to fi nalise the modifi cation and perform the
confi guration.
• On fi nalising the confi guration:
° "OK" appears if the confi guration is performed correctly;
° if an error is produced, the fl ashing "ERROR" message is displayed next to fi eld that
produced the error (sensor or actuator).
Note: prior to pressing [OK] to commence confi guration, the remote actuator
and/or the remote sensor must exist in the confi guration mode. Use the remote
actuator and sensor specifi cations to view the modes.
Note: the zone confi guration mode also allows verifi cation of whether the bus
peripherals are correctly connected. Press [OK] to enter parameter modifi cation
mode and successively press [OK] again to perform the connection test.
WARNING: a programmed zone can be deleted by entering [---] in the sensor
and actuator fi elds and then pressing [OK]. It is essential to perform this
operation before reconfi guring an already programmed zone.
ADV
ESC ESC
- 59 -
Athena
Instruction Manual
ADV
ESC ESC
and