Battery Status - Orbis Athena Manual De Instrucciones

BATTERY STATUS

• The battery charge (in percentage) is displayed in this
menu, which is designated by the symbol
• When the batteries are almost exhausted, this symbol
will also appear on the main page. The unit will
continue performing all functions, but will indicate that
the batteries will have to be replaced soon.
WARNING: with an exhausted battery, relay switching, wireless transmission
and bus communications cannot be guaranteed.
• When the batteries are removed, the unit's screen will switch off to reduce
consumption and allow them to be replaced. All functions except the clock will be
interrupted. Operating time without batteries is approximately two minutes.
• After replacing the batteries, the rest operations must be carried out as described in
the chapter "Initial reset".
ON/OFF PROGRAMMING
• It is possible to enable or disable the temperature adjustment for each zone from this
menu, designated by the symbol
ESC ESC
• After selecting the desired zone with the
modify the confi guration. Use the
press [OK] again to confi rm it.
Note: on going from OFF to ON, the operating mode will be the one prior to the
OFF state.
.
. By default, all zones are confi gured to "ON".
ESC ESC
and
and arrows to select the ON or OFF state and
- 61 -
Athena
Instruction Manual
ESC ESC
arrows, press the [OK] key to