Programming Menu - Orbis Athena Manual De Instrucciones

COUNTDOWN PROGRAM
• The countdown program permits programming the switch ON/OFF of the installation
on a pre-establish date.
• See the chapter "Timer Programming" on page 56 for countdown program
confi guration.
NOTE: the countdown program cannot be enabled once the extension program
has commenced.

PROGRAMMING MENU

• The eight available programming menus permit the confi guration of all unit operating
parameters.
• Press the [OK] key from the normal operating mode to access the programming
menus. Use the and
• These are the menus in order of appearance:
Date and time confi guration and summer/winter time change
Daily programming
Temperature programming
Timer programming
Zone adjustment parameter programming
Advanced programming
Battery status
ON/OFF programming
• Each menu can contain several confi gurable parameters: Use the arrows
to move through the all the parameters, then press the [OK] key to modify them.
DATE AND TIME CONFIGURATION AND SUMMER/WINTER TIME CHANGE
• See chapter "Time confi guration" on page 48 for date and time confi guration.
• Press or
] from the date and time menu to confi gure the summer/winter time
change .
• The enable/disable menu for automatic summer/winter time change will be entered,
which shows the current time (summer or winter) and the enabling status (ON if
arrows to move through the menus.
- 51 -
Athena
Instruction Manual
and