TECshow HALO 1R Manual De Usuario página 14

The conversion of three and five core plug (male and female)
Pin 1: GND (Screen)
Pin 2: Signal (-)
Pin 3: Signal (+)
Pin 4: N/C
Pin 5: N/C
Pin 1: GND (Screen)
Pin 2: Signal (-)
Pin 3: Signal (+)
6. MAINTENANCE
a. If the light's lens damaged or broken, and
should need change the new lens, if the bulb
damaged or have any deformation, make the
light dim, it says that the bulb had run out of it's
life., should change in time. There are 3 thermal
protection device, using for cut off the lights
power when it is heating. If the thermal pro-
tection device set up, and then need to check
whether the fan is normal.
b. It need Periodically to clean the out and in
optical lens and the reflector's. Out put for the
optimization lighting effect, clean time need
to see the lights operating frequency and the
using of the surrounding environment, using
the soft cloth or general glass cleaning products
to clean. Suggest clean the external optical
system every 20 day, at least clean the internal
optical system every 60 days.
c. Please don't to use the alcohol etc organic sol-
vent clean the out shell, in case it is damaged.
P. 14
Tecshow Halo 1R |
English version
Three core canon plug DMX512 interface circuit
Pin 1: GND (Screen)
Pin 2: Signal (-)
Pin 3: Signal (+)
Pin 1: GND (Screen)
Pin 2: Signal (-)
Pin 3: Signal (+)
Pin 4: N/C
Pin 5: N/C