Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
N o s e A s s e m b l i e s
F i t t i n g I n s t r u c t i o n s M a x l o k
Air supply must be disconnected when fitting or removing nose assemblies
•
Fit Locking Ring 8 onto the Chuck Collet Adaptor.
•
Lightly coat Jaws 4 with Moly Lithium grease.
•
Drop Jaws 4 into Chuck Collet 9.
•
Insert one Spring Guide 10 into Chuck Collet 9.
•
Locate Spring 7 onto the Spring Guide 10 already in place.
•
Drop the other Spring Guide 10 into Spring 7.
•
Holding tool pointing down, screw the assembled Chuck Collet onto the Chuck Collet Adaptor and tighten with spanner.
•
Screw Anvil Adaptor 15 into the Head Assembly.
•
Place Anvil 12 over Chuck Collet 9 and lock into place with Anvil Nut 16.
15
8
S e r v i c i n g I n s t r u c t i o n s
•
Remove nose assembly from tool using the reverse procedure to the fitting instructions above.
•
Clean parts. Worn or damaged parts should be replaced.
•
Check the Anvil 12 for wear and/or damage to the swaging bore.
•
Lightly coat Chuck Jaws 4 and Chuck Collet 9 internal bores with Molylithium grease.
•
Assemble as above instructions.
Item numbers in bold refer to the Maxlok
10
®
I M P O R T A N T
10
7
10
4
®
Nose Assembly on page 8.
9
12
16
Publicidad
Capítulos
Tabla de contenido
