Innotek FieldPro FP-RANGER-E Manual Del Propietário página 20

8. Realize that because dogs have
unique temperament, there is no way
of knowing how your dog will react to
the introduction of a remote training
system. For the safety of your dog, a
long lead should be used during
initial training so you have complete
control of the situation.
9. If you have reason to believe that
your dog may pose a danger to
others, harm itself, or react adversely
to the collar, do not rely solely on this
product to train your dog. If your dog
shows signs of growling, snarling, or
biting while using the collar, stop
immediately. Aggression in dogs has
many causes. We recommend that
you consult
professional dog trainer or animal
behaviorist who has experience with
aggressive dogs if your dog has
shown any of these characteristics.
10. Occasionally, a dog cannot be
trained to respond to a remote
training collar. Sometimes even a
properly trained dog may disobey a
command. Therefore, Innotek, Inc.,
its distributors, and dealers cannot
guarantee that the system will in all
cases keep the customer's dog from
disobeying commands.
11. To maintain maximum range, keep
the Transmitte antenna away from all
magnets, especially the very strong
magnet in the Receiver's charging
cradle. Exposure to a magnet may
permanently diminish range.
EN-20
a knowledgeable
COMPLIANCE WITH U.S. FCC AND
EUROPEAN TELECOMMUNICATIONS
REGULATIONS
®
This INNOTEK Remote Training System is
designed to meet worldwide requirements
for telecommunications compliance. This
system contains both Receiver and
Transmitter devices. This Class B digital
apparatus complies with Canadian ICES-
003, each transmitter device is compliant
with RSS-210 and each receiver device
complies with RSS-310 rules. The term
"IC:" before the radio certification number
only signifies that Industry Canada
technical specifications were met. In the
US, each transmitter device complies with
Part 95 and/or Part 15 of the FCC rules;
each receiver device complies with Part
15 of the FCC rules.
Each device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) this device
may not cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause undesired
operation.Changes or modifications not
expressly approved by Innotek, Inc. could
void the user's authority to operate the
equipment. Each device may display
indications as to where this system is
compliant worldwide. Note that in some
countries, the use of this INNOTEK
Remote Training System may be limited
due to national frequency planning
requirements, and the user is always
responsible for respecting national and
local rules before operating.
Innotek,Inc. declares that this 27.145 MHz
remote control radio transmitter is in
compliance with the essential
requirements and other relevant provisions
of Directive 1999/05/EEC. The Declaration
of Conformity can be found at:
http://www.innotek.net/world.shtml
FieldPro-E Owner's Manual