Connecting The Processor To Analog Components - Sony MDR-DS6500 Manual De Instrucciones

Notes on optical digital connecting cable
Do not drop objects on the optical digital connecting cable or

expose the cable to shock.
Grasp the plug to connect or disconnect the cable.

Be sure that the ends of the optical digital connecting cable

are kept clean. Dust at the ends of the cable can degrade
performance.
When storing the system, attach the cap to the end of the

plug and be careful not to fold or bend the optical digital
connecting cable with a bend radius less than 25 mm (1
inch).

Connecting the processor to analog components

Use an audio cord (sold separately) to connect the audio output jacks on a VCR, TV, or other
component to the LINE IN (L/R) jacks on the processor.
Processor
Audio right (R, red)
Connecting cables (sold separately)
Use the connecting cable (stereo mini-plug  pin plug  2) when connecting a stereo mini-jack
(headphones jack, etc.) to the LINE IN jacks.
In this case, set the volume on the player at a medium level. Noise can occur if the volume on the player is
set too low.
US
14
Connection
To audio output jacks
To LINE IN jacks
Audio left
(L, white)
Audio cord
(sold separately)
The bend radius of the optical digital
connecting cable should be no less
than 25 mm (1 inch).
VCR, TV, or other
component
Audio left
(white)
Audio right (red)
25 mm
(1 inch)