Panasonic EYFPA1J Manual De Instrucciones página 15

Display
Battery indication lamp
. Press the C button again.
• Radio signal range limitation function
on/off setting value will be displayed.
4. Press the and
signal range limitation function on/off.
Radio signal
Display range limitation
function mode
C0 OFF
C1 ON
Factory settings
• Radio signal range limitation function
setting: C0 (OFF)
NOTE:
• For more information about how to reg-
ister the tool and Assembly Qualifier,
see the Assembly Qualifier instruction
manual.
LED light setting
• You can select from two LED light modes.
1. Set the tool to setting configuration mode.
(See page 11.)
. Press the B button once.
• The current setting value will be dis-
played.
. Press the and
desired value.
Display
d1 Linked to LED light button
d Linked to trigger switch operation
buttons to set radio
Status
Tool is operational in the
absence of communica-
tions with the Assembly
Qualifier.
Tool is not operational
in the absence of com-
munications with the As-
sembly Qualifier.
buttons to set the
Function
4. Press the OK button to accept the new
setting.
NOTE:
• The tool ships with the LED light mode
set to d1 by default.
Speed control function
• The speed (RPM) can be changed with the
amount of depression of the trigger.
1. Set the tool to setting configuration mode.
(See page 11.)
. Press the B button three times.
• The setting value will be displayed.
. Press the
desired value.
Operation
P0
P1
4. Press the OK button to accept the new set-
ting.
Initializing all settings
Factory settings
• Torque clutch setting: "F" (torque con-
trol function off)
• Snug point detection level → L1
• Cross thread reduction function → R0
• Rundown error detecting function → 0
• Maintenance interval alarm function
→ 0
• Radio signal range limitation function
→ C0
• Buzzer setting → b0
• LED light setting → d1
• Speed control setting → P0
• This section explains how to revert all tool
settings to their default values at the time of
shipment from the factory.
• The error display will be turned off.
1. Set the tool to the setting configuration
mode.
(See page 11.)
. Press the C button.
• The control panel will begin flashing.
Display: The letter "F" flashes on and off.
Battery indication lamp: The upper and
lower bars of the battery flash on and off.
- 1 -
and buttons to set the
Function
Speed control ON
Speed control OFF
EN EN