Panasonic EYFPA1J Manual De Instrucciones página 9

V.
OPERATION
Comparison chart for EYFA1 / EYFA0
remote control
EYFA31 EYFA30
D button (P) Torque level button (V)
C button (Q) Format button (W)
B button (R) Interval set button (X)
A button (S) Torque set button (Y)
This operating instruction is written with
the contents of EYFA1 model.
In the case of use with EYFA0, refer to
the above chart and replace EYFA0 with
EYFA1.
Before Using the Remote
Control (Available as an
optional accessory)
See the illustration
Insert the battery
1. Pull out the battery holder.
1 Push in on the fastener as indicated by the
arrow.
2 Pull out the holder.
. Insert the battery and push the holder
back in.
NOTE:
• If the tool does not respond to the wire-
less remote control even when the
remote control is operated close to
the tool, the battery (CR0) is dead.
Replace it with a fresh battery.
• The included battery is provided for sam-
ple use and may not last as long as com-
mercially available batteries.
Wireless remote control range
Vertically
9
-  -
The remote control should be operated within
approximately 0 cm and approximately 60°
vertically and horizontally of the perpendicular
relative to the infrared receiver on the tool.
• Under the following circumstances, you may
not be able to operate the tool, even within
this range.
• If there is an object between the remote
control's transmitter and the tool's receiver.
• Use outdoors or in other environments
where the remote control receiver is
exposed to a strong light source, or when
the remote control transmitter or receiver is
dirty may cause the tool to fail to respond,
even when the remote control is used within
the operating range.
[Main Body]
CAUTION:
• If a tool holder is used with the
Panasonic EYF series assembly tools,
make sure the tool's trigger switch
doesn't hit the tool holder. It may run the
tool accidentally and result in battery
failure by unexpected battery discharge.
See the illustration
CAUTION:
• When operating the tool by depressing
the trigger, there may be a momentary
lag before rotation starts. This does not
signal a malfunction.
* This lag occurs as the tool's circuitry
starts up when the trigger is depressed
for the first time after installing a new
battery pack or after the tool has not
been used for at least 1 minute (or at
least  minutes when the LED is on).
Rotation will start without any lag dur-
ing second and subsequent operations.
NOTE:
• Quick ON/OFF operation results in a
slightly longer lag before the rotation
starts.
Switch and Forward/Reverse
Lever Operation
See the illustration
EN EN
10
11