Kenwood KDC-BT49DAB Manual De Instrucciones página 32

4 Rub the film antenna gently onto the
windscreen in the direction of the arrow
shown to allow it to stick firmly.
(F)
5
Remove the separator (tag 2) of film
antenna (F) vertically.
Separator (tag 2)
(F)
28
6 Set the postion of the protrusion of the
amplifier unit (G) with the K on the film
antenna (F) and paste.
Do not touch the lead terminal or the
pasting surface (adhesive side) of the
amplifier unit (G).
• When installing the antenna on the right
side
(G)
Earth sheet
(F)
Set the position of
the protrusion with
K mark
Lead terminal of the
film antenna (F)
Lead contact of the amplifier
unit (metal part)
• When installing the antenna on the left
side
(F)
Earth sheet
(G)
7 Remove the film covering the earth sheet
and paste the earth sheet on the metal
part of the vehicle.
Provide sufficient leeway for the earth sheet
so that it does not interfere with the interior
parts (front pillar cover). Also take care that
the interior parts do not interfere with the
amplifier unit (G).
Windscreen
Earth sheet
(G)
Front pillar cover
8
Wire the antenna cables.
Use cable clamper (H) to secure the
antenna to the pillar at several positions.
9
Attach the front pillar cover back to its
original position.
Be sure not to damage the earth sheet and
amplifier unit (G) when covering.
10 Connect the amplifier unit (G) to the DAB
input terminal on the rear of the unit.
11 Set [DAB ANT POWER] to [ON]. ( 4)