Drive Functions; Electric Adjustments - Vermeiren DX2 Basic Manual De Instrucciones

Drive functions

In drive mode use the drive profile button (8) to select a higher or lower driving
program (drive profile 1-5). These drive programs are programmed in the factory
to rise from slow to fast. The drive program you select appears in red text in the
middle of the display.
The top speed in any drive program can be changed using the menu selection
button (10) in the drive program selected.
slower faster
To drive the wheelchair in the direction you wish, move the joystick to the position
you want.
If the loading socket is plugged in, the wheelchair will be locked for drive functions.
If the joystick is moved, the display will also briefly show a red warning bar.
Make sure that the joystick is in the neutral (central) position when pressing the on/off button,
otherwise the electronics will be blocked. This block can be lifted by switching the operator
control off and then on again or just let go the joystick, now the joystick goes in neutral
position.
Always adapt your speed to the prevailing environmental conditions.

Electric adjustments

Select the program function using the field
selection button (9) and the display will show the
menu for the adjust functions.
Select left/right with the joystick or the menu
selection button (10) until the adjust function you
want appears in the centre of the display.
To adjust the selected function, move the joystick
in the direction you want up or down.
To switch back to the driving program, select the
drive profile button (8) in drive mode.
12
DX2 Operator control
vD - 2013-04
Return
function
Start
function