Using Battery Charge Indicator - Vermeiren DX2 Basic Manual De Instrucciones

Using battery charge indicator

The battery charge indicator is used to indicate that your wheelchair power is on
and provides an estimate of the remaining battery capacity.
Any green LED's indicate that your batteries are well charged.
If only amber and red LED's are light, the batteries are moderately charged.
Recharge your batteries before you make a long trip.
If only red LED's are light, the batteries are running out of charge. Recharge as
soon as possible.
The following table indicates what the battery charge indicator will display.
Display Description Meaning
All LEDs dark. System off.
All LEDs are System on.
flashing.
All LEDs are lit. System on.
Only red and yellow Low battery level.
LEDs lit.
Only red LEDs lit. Very low battery level.
Red LEDs are Battery almost empty.
flashing.
1 Red Led is Battery empty.
flashing.
The LEDs turn on
one by one from left
to right.
The LEDs turn on
one by one from left
to right, followed by
one second where
the current battery
capacity is
displayed.
All leds turn on one Indicate that the chair will
by one from left to not drive.
right. The Fault
indicator will show
corresponding flash
code.
6
DX2 Operator control
vD - 2013-04
Remarks
Warning: battery too full.
Slow down if you are
driving down a slope.
LEDs show the charge
level.: Full battery
Battery half full. Start the
return journey.
Battery low. Recharge
soon.
Recharge now.
Recharge immediately.
Drive inhibit, the chair will
not drive.
The charger is connected to
the operator control.
A fault has occurred.