Input Gain - Amate Audio TPD Manual De Usuario

TPD
6.1.4 Version Info
Shows software and hardware information about the device. Turn the rotary knob to
display the information available:
Version Info
SN: 0000010262
Version Info
HW: 4.9.3
IP Address
000.000.000.000
NOTE: In TPD, where no network card is available, IP Address and MAC Address
are shown with default values (all zero).
6.2 Input Menus
To access the Input Menus press the <Channel or Channel> key. Press Exit to finish
editing or again <Channel or Channel> to edit other channels.
The following menus are available for each input channel. Please note that by
default the input channels are linked. The following options are shown for the input
group composed of InL and InR (InLR).
6.2.1

Input Gain

Adjust the gain of each input, using the rotary knob. Maximum value is 0dB.
In LR Gain
-1.25dB
6.2.2 Delay
Adjust the delay by turning the rotary knob. Push this knob to switch the unit
between ms, ft or m.
In LR Delay
Signal
0.090ms
6.2.3 Crossover
• Low Pass – First adjust the Low Pass Filter cut-off frequency. To switch it off, turn
the rotary knob clockwise until frequency reaches 20 kHz.
Second, press the rotary knob and select from the available types and slopes:
Type: Butterworth, Slopes: 6dB, 12dB, 18dB or 24dB
Type: Bessel. Slopes: 6dB, 12dB, 18dB or 24dB
Type: Linkwitz-Riley. Slope: 12dB or 24dB
17
Version Info
SW:10.0.8.112796
MAC Address
0000:00:00:00:C0
Jul 2016
Amate Audio