Amate Audio TPD Manual De Usuario página 21

TPD
6.3.3 Delay
Adjust the delay by turning the rotary knob. Push this knob to switch the unit
between ms, ft or m.
OutL2 Delay
Signal
0.000ms
6.3.4 Crossover [see Table 4]
• Low Pass – First adjust the Low Pass Filter cut-off frequency. To switch it off, turn
the rotary knob clockwise until frequency reaches 20 kHz.
Second, press the rotary knob and select from the available types and slopes:
Type: Butterworth, Slopes: 6dB, 12dB, 18dB or 24dB
Type: Bessel. Slopes: 6dB, 12dB, 18dB or 24dB
Type: Linkwitz-Riley. Slope: 12dB or 24dB
Finally, select to enable or disable the filter: Enabled On/Off.
OutL2 LowPass
XOver
Freq: 1500Hz
• High Pass – First adjust the High Pass Filter cut-off frequency. To switch it off, turn
the rotary knob counter-clockwise until frequency reaches 20 Hz.
Second, press the rotary knob and select from the available types and slopes:
Type: Butterworth, Slopes: 6dB, 12dB, 18dB or 24dB
Type: Bessel. Slopes: 6dB, 12dB, 18dB or 24dB
Type: Linkwitz-Riley. Slope: 12dB or 24dB
Finally, select to enable or disable the filter: Enabled On/Off.
OutL2 HighPass
XOver
Freq: 40Hz
6.3.5 Parametric EQ
Select between one of the 10 available Equalizers on each output channel by using
the keys < Select and Select >. Browse the parameters by turning the rotary knob
and push the knob to select and confirm the values. The following parameters can
be adjusted for each EQ:
• Enabled – When set On, the currently selected EQ is on line.
OutL2 PEQ 1
Enabled: On
21
OutL2 LowPass
XOver
Type: BUT 24dB
OutL2 HighPass
XOver
Type: BUT 24dB
Jul 2016
Amate Audio