The Rear Panel - Amate Audio TPD Manual De Usuario

TPD
I) LCD - Shows all the necessary information to control the unit.
J) Rotary Thumb Wheel – Click and turn to change the overall input gain (volume)
of the system. Inside the menus, turn the wheel to change parameter data values
and click on it to confirm the value entered. The center click of the wheel is also
used to browse different parameters of the same feature.
K) Output signal LEDs - Show the current level of the output Signal: Signal (-
48dBu), -6dBu, Limit (orange), The Limit led lights up if a gain reduction is taking
place (due to a programmed compressor).

3.2 The rear panel

Fig. 2. Rear panel view
A) Power switch with thermal breaker - Controls power On/Off. Automatic switch
off if overconsumption takes place.
B) Main Power - Connects via a standard IEC socket. A compatible power cord is
supplied with the unit. The input voltage range is 85 to 240VAC, 50-60Hz.
C) Speakon Output (SW, L, R) – Loudspeaker output connections via 2-pole
Speakon. Recommended output for connecting the amplifier with the acoustic
system.
D) Binding Posts – Separate outputs of each channel. This connector is connected
in parallel with the Speakon Output and they are recommended when requiring a
wire section greater that the Speakon Output.
E) FAN – Forced ventilation turbine. Do not cover.
F) XLR inputs (L, R) - Electronically balanced
G) XLR auxiliary outputs (processed) - Separate 3-pin XLR connectors are
provided for each auxiliary output. The device's output stage employs the
balanced impedance topology.
6
Jul 2016
Amate Audio