Using The Bread-Maker; Before First Use; Operation - SEVERIN BM 3992 Instrucciones De Uso

9
10 -
11
Important information
– If you observe flour residue on the walls of the baking-tin, open the lid during the kneading
phase, and use a rubber scraper to move the flour back into the dough so that it can be properly
processed.
Close the lid afterwards.
– When using yeast, the kneading hook may be removed after the final kneading phase.

USING THE BREAD-MAKER

Your new bread-maker allows you to:
– bake breads to various recipes, some of which can be found in the appendix to this manual.
However, this bread-maker also allows you to use commercially available ready-to-bake mixtures
with up to 500g of solid ingredients (for a loaf of up to 1000g).
- The two smaller baking tins can be used for making smaller loaves.
The volume of the two smaller tins is about 2/3 of the large baking-tin volume.
– knead dough for bread rolls, pizza etc., and let the dough rise.
– Only recipes with a flour content of 200 – 550g should be used with this bread-maker. Use 1 ½
teaspoons of yeast for wheat flour, and 2 teaspoons for rye flour.
Should the flour content fall short of this minimum, thorough kneading of the dough cannot be
ensured. Excessive flour content may result in the dough rising over the edge of the baking-tin.

BEFORE FIRST USE

– Remove the baking-tin.
– Before the bread-maker is used for the first time, it should be thoroughly cleaned, as described in
the section Cleaning and Care.
– Fit the kneading hooks into their sockets inside the baking-tin and fill the tin with around 125ml
of water.
– Replace the baking-tin in the unit. Make sure that it locks firmly into place.
– Insert the plug into a suitable wall socket.
– Use the
button to select programme 11 (BAKING).
– Press the -button and let the unit heat up for approximately 10 minutes with the lid open. This
will remove the smell typically encountered when first activating the heating elements. Ensure
sufficient ventilation.
– Afterwards, press and hold the
(this is confirmed by an acoustic signal); now remove the plug from the wall socket and allow
the appliance to cool down.
– Clean the unit again as described in the section

OPERATION

– Open the lid and remove the baking-tin.
– Fit the kneading hooks into their sockets inside the baking-tin.
3:55
- 1:05
1:00
-button for approx. 3 seconds to switch the bread-maker off
2:55 60
0:15 50
- 60
Cleaning and Care.
26
60 57
- -
60 -