Synchronization Interval - ZIV IDV-A Serie Manual De Instrucciones

DNP Protocol Configuration
Relay Number

Remote Terminal Unit Address. Addresses 0xFFF0 to 0xFFFF are reserved as Broadcast
Addresses.
T Confirm Timeout

Timeout while waiting for Application Layer Confirmation. It applies to Unsolicited
messages and Class 1 and Class 2 responses with event data.
Max Retries

Number of retries of the Application Layer after timeout while waiting for Confirmation.
Enable Unsolicited

Enables or disables Unsolicited reporting.
Enable Unsol. after Restart

Enables or disables Unsolicited after Restart (for compatibility with terminals whose
revision is before DNP3-1998). It has effect only if Enable Unsolicited after
Restart is set.
Unsolic. Master No

Destination address of the Master device to which the unsolicited responses are to be sent.
Addresses 0xFFF0 to 0xFFFF are reserved as Broadcast Addresses. It is useful only when
Unsolicited Reporting is enabled.
Unsol. Grouping Time

Delay between an event being generated and the subsequent transmission of the
unsolicited message, in order to group several events in one message and to save
bandwidth.

Synchronization Interval


Max interval time between two synchronization. If no synchronizing inside interval,
indication
IIN1-4 (NEED TIME).
is zero.
DNP 3.0 Rev

Certification revision
(IED) Certification Procedure Subset Level 2 Version 2.3 29-Sept-03)
Atención © ZIV Aplicaciones y Tecnología, S.A. Zamudio 2004
Este documento contiene información confidencial propiedad de ZIV S.A. Cualquier forma de reproducción o
divulgación está absolutamente prohibida y puede ser causa de severas medidas legales.
DNP 3.0 : Device Profiles Document
RTU Address ):
(
(N7 Confirm Timeout) :
(N7 Retries) :
(Enable Unsolicited Reporting) :
MTU Address) :
. (
(Unsolicited Delay Reporting) :
This setting has no effect if
.
STANDARD ZIV or 2003 (DNP3-2003 Intelligent Electronic Device
20 of 84
Page
:
Synchronization Interval