Use Your Product; Adjust The Volume; Choose Your Sound; Sound Mode - Philips Fidelio E6/12 Manual Del Usuario

Note
•
Spatial calibration takes around three minutes.
•
Surround sound improvement is only noticeable if the
wireless surround speakers were improperly placed, or
if there is strong surround effect in the music you play.
•
If the wireless surround speakers are swapped in
placement, at the end of calibration L<->R is displayed
for few seconds, then the calibration completes.
•
During calibration, you may press CALIBRATION
to cancel calibration, and the settings returns to the
default.
•
If the spatial calibration fails, an error message is
displayed on the display panel, such as FAIL (fail), and
the settings returns to the default.
•
If the spatial calibration fails, try the spatial calibration
again, and make sure that the calibration points
described at the beginning of this chapter are fully met.
6 Use your
product
This section helps you use this product to play
audio from connected devices.
Before you start
• Make the necessary connections described
in the quick start guide and the user
manual.
• Switch this product to the correct source
for other devices.

Adjust the volume

1
Press Volume +/- to increase or decrease a
volume level.
• To mute sound, press .
• To restore the sound, press
press Volume +/-.
For the wireless surround speakers only
1
When the wireless surround speakers
are wirelessly connected to the main unit
(in SOD mode), press
increase or decrease a volume level.

Choose your sound

This section helps you choose the ideal sound
for your video or music.

Sound mode

Select predefined sound modes to suit your
video or music.
• Press to create a surround listening
experience. Ideal for watching movie.
• Press to create two-channel or
multi-channel stereo. Ideal for listening to
music.
again or
to
EN
17