Pairing - Sony HWS-BTA2W Manual De Instrucciones

Pairing

Check the following before operating the unit.
– The TX/RX switch is set to "RX."
– This unit is connected to a power source and the 1 indicator (green) goes off.
1
Press and hold the ID SET button for 7 seconds or more.
When the 1 indicator (green) and
button. This unit enters pairing mode.
Note
Pairing mode is canceled and this unit is turned off after about 5 minutes. If this unit is turned off
while performing the procedure, start over from step 1.
2
Perform pairing procedure on the BLUETOOTH stereo audio source
device to detect this unit.
The list of detected devices appear on the display of the BLUETOOTH stereo audio
source device.
This unit is displayed as "HWS-BTA2W."
If "HWS-BTA2W" is not displayed, repeat from step 1.
Notes
• When pairing, be sure to place both the BLUETOOTH devices within 1 m (3 ft) of each other.
• Some devices cannot display the list of detected devices.
3
Select "HWS-BTA2W" appeared on the display of the BLUETOOTH
stereo audio source device.
12
US
indicator (blue) start flashing together, release the