Makita LH1201FL Manual De Instrucciones página 13

ENGLISH
(Original instructions)
1 Bolt
2 Lower blade guard A
3 Top blade guard
4 Lower blade guard B
5 Screw
6 Hex bolt
7 Handle
8 Lever
9 Top surface of turn base
10 Periphery of blade
11 Guide fence
12 Pointer
13 Lock lever
14 Grip
15 Miter scale
16 Bevel scale
17 Power switch
18 Lamp switch
19 Laser switch
20 Lamp
21 Stopper pin
22 Top table
23 Motor housing
24 Center cover
25 Socket wrench
26 Shaft lock
27 Saw blade
28 Blade case
SPECIFICATIONS
Model
Blade diameter .................................................................................................................................................... 305 mm
Blade body thickness.................................................................................................................................1.9 mm or less
Hole diameter
For all countries other than European countries ..............................................................................................25.4 mm
For European countries ......................................................................................................................................30 mm
Max. Cutting capacities (H x W) with blade 305 mm in diameter in the miter saw mode
Bevel angle
90°
45°
Max. Cutting capacities at 90° in the table saw (bench saw mode) ...................................................................... 52 mm
–1
No load speed (min ) ............................................................................................................................................ 3,800
Laser Type...................................................................................................Red Laser 650 nm, < 1 mW (Laser Class 2)
Table size (W x L) ............................................................................................................................... 307 mm x 465 mm
Dimensions (L x W x H) .....................................................................................................610 mm x 535 mm x 692 mm
Net weight ............................................................................................................................................................ 20.9 kg
............................................................................................................................................
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Explanation of general view
29 Arrow
30 Outer flange
31 Inner flange
32 Spindle
33 Ring
34 Riving knife
35 Area to press in
36 Hex bolts
37 Blade width
38 Rip fence holder
39 Guide rail on the top table
40 Clamping screw (A)
41 Clamping screw (B)
42 Rip fence
43 Line to be aligned with
44 Workpiece
45 Square nut
46 Washer
47 Scale
48 Adjusting screw
49 Dust nozzle
50 Dust bag
51 Fastener
52 Vacuum cleaner
53 Blade cover
54 Support
55 Turn base
56 Sub-fence
90°
95 mm x 155 mm
62 mm x 200 mm
64 mm x 155 mm
40 mm x 200 mm
57 Vise arm
58 Vise rod
59 Holder
60 Vise knob
61 Projection
62 Vise shaft
63 Base
64 Vise
65 Spacer block
66 Aluminum extrusion
67 Small boss
68 Face/edge parallel
69 Wood screw
70 Glue together
71 Hole (7 mm in diameter)
72 Push stick
73 Auxiliary fence
74 Push block
75 Triangular rule
76 0° bevel angle adjusting bolt
77 Top surface of turn table
78 Arm
79 45° bevel angle adjusting bolt
80 Screwdriver
81 Brush holder cap
82 Knob
Miter angle
45° (left to right)
95 mm x 110 mm
62 mm x 135 mm
64 mm x 65 mm
40 mm x 85 mm
LH1201FL
/II
13