Cleaning And Maintenance; Routine Maintenance; Special Maintenance; Control And Safety Devices - Bartscher GG740 Manual De Instrucciones

Ocultar thumbs

página de 36

/ 36
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

3.1 ROUTINE MAINTENANCE

At the end of the working day, clean the appliance, both for reasons of hygiene and to prevent operating faults.

Do not clean the appliance with direct or high-pressure jets of water and do not use metal pads, brushes or scra-

pers in normal steel. If necessary, use stainless steel pads, but do not rub them against the grain of the metal of

the appliance.

Do not allow acid foods (lemon, vinegar, etc.) to remain on steel parts. Use warm soapy water on steel surfaces

and then rinse in plenty of water and dry with a soft cloth. Maintain the shine by regular polishing with a normal

liquid polish.

Clean the grid frequently, using a wet cloth. Do not use detergents that contain chlorine (bleach, hydrochloric

acid, etc), not even in diluted form. Next, operate the grid for a few minutes by turning the knobs to maximum to

dry it as rapidly as possible.

The volcanic rock can be cleaned by plunging it into boiling water to remove accumulated grease.

Do not wash the work top or ﬂ oor with hydrochloric acid.

ASH BOX

This must be checked regularly during use and must then be emptied.

3.2 SPECIAL MAINTENANCE

At regular intervals (at least once a year or more often in cases of frequent use), service the appliance thoroughly.

This includes checking the gas circuit, checking parts for damage and if necessary lubricating the taps if they are

difﬁ cult to use. Contact a specialised and experienced technician. A maintenance contract should be taken out

with a centre approved by the company.

3.3 CONTROL AND SAFETY DEVICES

If the appliance is not used for a long time or if it does not work or works irregularly, the gas stopcock upstream

of the appliance must be shut off. All the parts of the appliance that are subject to wear can easily be accessed

from the front of the appliance by opening the door or after removing the front. All the couplings use a dado and

bicono, so great care must be taken in handling these components. If the part is damaged during dismantling or

reassembly it must be replaced with a new one.

3.4

MANAGING SPARE PARTS

The spare parts must be replaced only by

personnel of an authorised Customer Servi-

ce Centre. Use the list alongside to identify

the spare parts codes or contact Customer

Service, which will identify them and will send

a written order to the manufacturer clearly

stating the appliance model, the serial num-

ber, as well as the code and a description of

the parts concerned.