Solter AEROTIG 3320 DC Manual De Instrucciones página 29

Time of start ramp
Time that the machine takes to move from the initial current to the main current (A1)
Main welding current (A1)
In pulsed arc mode, it is a double parameter and the time of this current can be set.
Time of the main welding current (A1)
In pulsed arc mode, this parameter determines the time the machine is supplying the A1
current.
Secondary current, A2
The welding current That the machine will supply when we activate the secondary button
in normal TIG mode, or to be held with the scheduled time or frequency pulsed arc.
In pulsed arc mode it is a double parameter and its time can be set.
Time of A2 welding current
In pulsed arc mode, this parameter determines the time the machine is supplying the A2
current.
Adjusting the frequency of high-speed pulsed arc
Only if this mode has been selected.
Time stop ramp
Time that the machine takes to move from the main current to the standstill current.
Standstill current
The value is a % of the A1 current.
In 4T mode, this current value will remain while we press the torch button.
Post-gas Time
Time that the machine takes to stop the gas after welding.
SOLTER SOLDADURA S.L. 10