Included Parts - Kawai ES7 Instrucciones De Montaje

HM-4 Assembly Instructions
Thank you for purchasing this accessory for the Kawai ES7/ES8 digital piano.
Please read these assembly instructions thoroughly before attempting to assemble the HM-4 digital piano stand.
1. Do not use this HM-4 stand for any purpose other than its intended use as a piano stand.
2. At the final stage of assembly, ensure that all screws are firmly tightened.
3. Do not drag the product along the floor. Take care not to drop the product.
4. Do not stand on the product or exert excessive force.
5. If any screws are found to be loose, tighten them immediately.

Included parts

Before attempting to assemble the HM-4 digital piano stand, please ensure that all parts below are included.
A Phillips-head screwdriver (not included) will also be required in order to assemble the stand.
a Side Boards (left, right)
1. Assembling the side boards and back board
Attach the Back Board b to the left and right Side Boards a
using two screws d on either side.
Place Caps e over the four screws.
* Ensure that all four screws are firmly tightened.
2. Adjusting the fall prevention glides
If the instrument will be placed away from a supporting wall,
the tip-prevention glides should be used to improve the stand's
stability.
Remove the two screws, then reposition and reattach the glides
located on the underside of the left and right Side Boards a.
The extended glides should protrude outward, improving the
stand's stability.
2
b Back Board x 1 c Music Rest x 1
e
d
b
Screws
d Screw x 4
e Cap x 4
f Knob x 4
a
Glide