Included Parts - Kawai ES100 Instrucciones De Montaje

F-350 Assembly Instructions
1. Do not use this F-350 for any purpose other than its intended use as a piano pedal unit.
2. At the final stage of assembly, ensure that all screws are firmly tightened.
3. Do not drag the product along the floor. Take care not to drop the product.
4. Do not stand on the pedal unit or apply undue force on it.
5. If any screws are found to be loose, tighten them immediately.
6. Ensure that the adjuster bolt firmly touches the floor, supporting the pedal unit and preventing instability or
damage.
7. When moving the piano, raise the Adjuster Bolt and readjust after moving.
 Included parts
Before attempting to assemble the ES100/ES110 digital piano stand, please ensure that all parts below are included. A Phillips-
head screwdriver (not included) will also be required in order to assemble the stand.
(including adjustor bolt)
1. Pull out the pedal cable
Unfasten and extend the pedal connection cable attached
to the bottom of the pedal board
2
A
Pedal board
A
.
a
Screw (5x25mm) x 4
2. Attach the pedal board
A
Fix the pedal board to the stand using four screws
* When it is difficult to engage the pedal board with the
stand, slightly loosen the screws fixing the back board
of the stand.
* Remove if any hole patches have been stuck to hide holes
in the stand.
a
a
A
to the stands (HML-1)
a
.
B
A
a
a
B