Included Parts - Kawai ES100 Instrucciones De Montaje

HML-1 Assembly Instructions
1. Do not use this stand for any purpose other than its intended use as a piano stand.
2. At the final stage of assembly, ensure that all screws are firmly tightened.
3. Do not drag the product along the floor. Take care not to drop the product.
4. Do not stand on the product or exert excessive force.
5. If any screws are found to be loose, tighten them immediately.
6. Do not lean on the piano.
 Included parts
Before attempting to assemble the ES100/ES110 digital piano stand, please ensure that all parts below are included. A Phillips-
head screwdriver (not included) will also be required in order to assemble the stand.
A
Side Board 1
Back Board
1. Adjusting the fall prevention glides
If the instrument will be placed away from a supporting wall, the tip-prevention glides should be used to improve the stand's
stability. Remove the two screws, then reposition and reattach the glides located on the underside of the left and right Side
A B
Boards . The extended glides should protrude outward, improving the stand's stability.
2
B
Side Board 2
C
Screw
a
Screw (6x60mm) x 4
Cap x 4
b
c
Screw (5x25mm) x 4
d Hole patch x 8
Glide