Epson L120 Guia De Instalacion página 3

L120
Start Here
1
Unpack
Note: The ink bottles and printer cables may be packed inside the product. The included ink bottles must be used for product setup and are not for resale.
2
Fill ink tanks
Note: This product requires careful handling of ink. Wear plastic gloves and place a sheet of
paper under the ink tank unit when you fill or refill the ink tanks, as ink may splatter. If ink spills,
wipe it off immediately to avoid permanent stains. If ink gets on your clothes or belongings, it
may not come off.
Press the
the power and
3
Load paper
Caution: Replace bottle cap tightly, or ink may leak.
power button and wait until
cancel lights stay on.
Read these instructions before using your product.
Caution: Do not open the ink bottles until you are ready to fill the ink tanks. The
ink bottles are vacuum packed to maintain reliability. Never place the product on
its side after the ink tanks are filled.
Warning: Keep ink bottles out of the reach of children and do not drink the ink.
During initial setup, make sure to use the ink bottles that came with
your product and use all of the ink.
Fill each tank with the correct ink color.
Press and hold the
until the
takes approximately 20 minutes. Ink charging is
complete when the
cancel button for 3 seconds
power light starts flashing. Ink charging
power light stops flashing.