General Instructions; Maintenance Tips; Control Panel - Vitamix BARBOSS ADVANCE Manual De Uso Y Cuidado

G E N E R A L I N ST R U C T I O N S

Maintenance Tips:

• Never bang the container against a surface to loosen the ingredients.
Remove the container from the base and use a rubber spatula to remove
thick mixtures from the bottom of your container.
• Never shake or rattle a container while in use.
• Never remove the container before the machine has come to a complete stop.
• Never start the motor before the container is in place.
IMPORTANT NOTES!
The automatic overload protection shuts the motor off to protect the motor.
The motor may stop working if it is overloaded or overheated.
If the motor shuts off, it could be due to:
• Recipe being too thick
• Recipe having too many ingredients in it
• Recipe was being processed too long at too low a speed
If the motor shuts off, review your processing techniques and your instructions.
Thermal Protector: The thermal protector may shut the motor off to protect it
from overheating. To restart, wait for motor to cool down with the power off (up to
45 minutes). Cooling may be quickened by placing the motor base in a cool spot.
(Unplug first.) To speed up the process, try circulating the air with a vacuum or fan
aimed at the bottom of the base. When the thermal protector shuts the motor off,
review your processing techniques and your instructions. Your recipes may be too
thick or have too much material in them. If the motor seems to be overheating but
the thermal overload protector has not turned the machine off, stop the machine
and remove the container from the base. Turn the machine on and let the machine
run for 20 seconds. Repeat this step 3 times for a total of 1 minute. Be careful never
to touch any moving parts while in use.
8
CO N T R O L PA N E L
Start/Stop Switch Program Dial
BarBoss® Advance®
and Drink Machine Advance®
On/Off Switch: Located on the front of the machine below the
control panel (Figure A). The On/Off switch controls the power
to the machine. While plugged in, switch to on to ready the
machine for blending. Shut off the power switch at night or
FIGURE A
whenever the machine will be left unattended.
Start ( ) / Stop ( ) Switch: This is a lighted switch. When light is lit,
power is on. Depress the start switch to activate program setting and again to
stop a program mid-blending cycle. During operation, you may interrupt a
program by pressing the Start/Stop switch.
Program Dial: Allows user to select a number of pre-programmed settings.
Machine will shut off automatically at the end of the program. Program is
activated only when the power switch is on. See page 10 for programming details.
Pulse Switch ( ) : The pulse switch can be used to quickly refresh contents of the
container by depressing the switch and holding down as long as needed. The pulse
switch can only be used when the power switch is on.
Pulse Switch
9