Names And Functions Of Parts (Main Unit) - Tascam 202 MKVII Manual Del Usuario

A
J
A
Cassette compartment
B
RETURN TO ZERO button
Press to return the tape to the "
stop (page 17) .
C
COUNTER RESET buttons
Press to reset the tape counter to "
D
Remote control signal receiver
When operating the remote control, point it towards here .
E
DIMMER button
Press to change the brightness of the display .
F
REPEAT button
This allows repeat playback of a selected section of the tape
(page 18) .
G
PARALLEL REC (parallel recording) button
This button starts recording to both TAPE 1 and TAPE 2 simulta-
neously (page 24) .
H
Display
This shows tape counters, level meters, etc (page 13) .
I
DUB START (dubbing start) button
This button is used when copying the contents of a tape from
TAPE 1 to TAPE 2 at normal speed (page 23) .
o Dubbing from TAPE 2 to TAPE 1 is not possible .
o Dubbing at high speed is not possible .
10

Names and functions of parts (main unit)

B C D E F G H I
K L M
" counter position and
" .
C B
O L R
J
POWER button
Press to turn the unit on and off .
K
PITCH CONTROL knob
This adjusts the playback pitch . This does not function when
recording or dubbing (page 17) .
L
Cassette tape operation buttons
RECORD (0) button
Use when recording .
Press to start recording standby (page 18) .
PAUSE button
Press to pause playback/recording .
Press again to resume playback/recording .
REC MUTE (record muting) button
Use to create a silence of about four seconds when recording
or in recording standby (page 20) .
Rewind/fast-forward (m/,) buttons
Use these buttons to rewind/fast-forward .
Stop (8) button
Press to stop playback, recording, rewinding or fast-forwarding .
PLAY (y) button
Press to start cassette tape playback .
Press when playback/recording is paused to resume playback/
recording .
EJECT (-) button
Press to open the cassette compartment when the tape is
stopped .
A
P Q