Mic Mixing With Recording - Tascam 202 MKVII Manual Del Usuario

Mixing line input sounds when
recording
You can mix in the sound of a mic connected to this unit with an
audio source from a connected device when recording .
You can also record only the sound from the mic .
This unit does not support stereo mics.
Use a mono mic.
Connect the mic plug to the MIC connector on the front of the unit,
and follow the recording procedures (page 18) to record .
When adjusting the recording level in step 3 of the recording proce-
dures, adjust both the source and mic levels as follows .
1
Adjust the source level.
Play the source back and adjust the REC LEVEL (recording level)
knob so that the level is slightly low .

Mic mixing with recording

2
3
Continued on the next page
Adjust the mic level.
While inputting sound with the mic, turn the mic LEVEL knob
to adjust the balance between the source and mic sounds .
Adjust the overall level.
Play the source back and, while inputting the mic sound, adjust
the REC LEVEL (recording level) knob so that the peak level
meter never exceeds 0 continuously .
After adjusting, continue to the recording procedure (step 4) on
page 19 .
o The volume may differ depending on the recording source .
In order to record different sources at appropriate volumes,
you must adjust the recording level for each source .
o The mic sound will be placed equally in both left and right
channels so that it sounds centered .
o Connect the source directly to the analog audio input (LINE
IN) connectors, or select it on the amplifier connected to the
LINE IN connectors (page 14) .
e
21