Panasonic EY75A7 Manual De Instrucciones página 10

EN
• Do not charge the battery pack in a
high-temperature location, such as next
explode.
• After removing the battery pack from
the tool or the charger, always reattach
the pack cover. Otherwise, the battery
contacts could be shorted, leading to a
• When the Battery Pack Has Deteriorat-
ed, Replace It with a New One. Contin-
ued use of a damaged battery pack
may result in heat generation, ignition
or battery rupture.
• To prevent leakage, overheating,
from occurring, follow these instructions
when handling our rechargeable power
tools (tool main body/battery pack/
charger).
- Do not allow material cuttings or dust
to fall onto the battery pack.
- When storing, remove any material
cuttings and dust from the battery
pack, and place the battery pack
separately from metal objects
(screws, nails, etc.) when storing in
the tool case.
• Do not handle the rechargeable power
tools in the following way.
(There is a hazard of smoke genera-
- Use or leave in places exposed to
rain or moisture
- Use submerging in water
II.
Disconnect battery pack from tool or
place the switch in the center position
(switch lock).
1. Hold the collar of quick connect chuck
and pull it out from the driver.
2. Insert the bit into the chuck. Release
the collar.
3. The collar will return to its original
position when it is released.
4. Pull the bit to make sure it does not
come out.
5. To remove the bit, pull out the collar in
the same way.
Use 6.35 mm hexagonal bits.
To ensure proper securement of the bit,
use only hexagonal bits with 9.5 mm
detent. [Fig.1]
[Fig.2]
1. Attaching Socket
Attach the socket by aligning the hole
with the ball detent on the square drive.
ed to the body.
2. Removing Socket
Pull out the socket.
Keep the body above freezing point
(0°C) when attach or detach sockets to
the square drive on the body. The
cushion rubber in the square drive to
push up the ball may get hard under
freezing point. This requires extra force
in attaching and detaching sockets.
Pack
1. To attach the battery pack: [Fig.3
Align the highlighted marker points and
attach battery pack.
Slide the battery pack until it locks into
position.
2. To remove the battery pack: [Fig.3
Push the button and slide the battery
pack forward.
III.
• Do not inhale any smoke emitted from
the tool or battery pack as it may be
harmful.
- 10 -
-
]
]