Battery Recycling - Panasonic EY75A7 Manual De Instrucciones

(Green)
Turn off

Battery Recycling

For environmental protection and recycling of materials, be sure that it is disposed of at
• Use only a dry, soft cloth for wiping the unit.
Do not use a damp cloth, thinner, benzine, or other volatile solvents for cleaning.
• In the event that the inside of the tool or battery pack is exposed to water, drain and allow
tool. If you experience any problems operating the tool, consult with a repair shop.
• Use only suitable size of bit.
• Panasonic original optional quick
change chuck (EY9HX131E).
Chuck Size: 6.35 mm hex
Charging is completed. (Full charge.)
Battery is approximately 80% charged.
Now charging.
Charger is plugged into the AC outlet. Ready to charge.
Charging Status Lamp.
(Orange)
Left: green Right: orange will be displayed.
Battery pack is cool.
The battery pack is being charged slowly to reduce the load on
the battery.
Battery pack is warm.
Charging will begin when temperature of battery pack drops. If
the temperature of the battery pack is -10° or less, the charging
when the temperature of the battery pack goes up.
Charging is not possible. Clogged with dust or malfunction of
the battery pack.
Illuminated
These symbols indicate separate collection of waste electrical
and electronic equipment or waste batteries.
More detailed information is contained in the full version Operat-
ing Instructions.
https://www.panasonic-powertools.eu/en/construction/documents.htm
Flashing
Do not use the unit to drill holes into
wood and metal.
- 15 -
EN