Troubleshooting; Specifications - Sony CDP-CE505 Manual De Instrucciones

Troubleshooting

If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There's no sound.
/Check that the player is connected securely.
/Make sure you operate the amplifier correctly.
/Adjust the playback level using the PHONE
LEVEL control on the player (CDP-CE505 only)
or LINE OUT LEVEL +/– on the remote.
(except for CDP-CE305 and CDP-C661)
The CD does not play.
/There's no CD inside the player ("no DISC"
appears). Insert a CD.
/Place the CD with the label side up on the disc
tray correctly.
/Clean the CD (see page 18).
/Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 2).
The remote does not function. (except for CDP-CE305 and
CDP-C661)
/Remove the obstacles in the path of the remote
and the player.
/Point the remote at the remote sensor g on the
player.
/Replace all the batteries in the remote with new
ones if they are weak.
The player functions incorrectly.
/The microcomputer chips may be operating
incorrectly. Turn the power off, then turn it
back on to reset the player.
Additional Information Additional Information
Additional Information

Specifications

Compact disc player
Laser Semiconductor laser (λ = 780 nm)
Emission duration: continuous
Max 44.6 µW*
Laser output
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequency response 2 Hz to 20 kHz ± 0.5 dB
Signal-to-noise ratio
CDP-CE505: More than 107 dB
CDP-CE405/CE305/C661: More than
102 dB
Dynamic range More than 98 dB
Harmonic distortion CDP-CE505: Less than 0.0035%
CDP-CE405/CE305/C661: Less than
0.0045%
Channel separation More than 100 dB
Output
Jack Maximum
type
output
level
LINE OUT Phono
2 V
jacks
(at 50 kilohms)
DIGITAL OUT Optical
–18dBm
(OPTICAL) output
(CDP-CE505
connector
only)
PHONES
Stereo
10 mW
(CDP-CE505 phone jack
only)
General
Power requirements
Where purchased Power requirements
220 V – 230 V AC, 50/60 Hz
Europe, China, and
Singapore (except for the
CDP-C661 in Singapore)
Canada 120 V AC, 60 Hz
Other countries, and the 110 V – 120 V or 220 V – 240 V AC,
CDP-C661 in Singapore adjustable, 50/60 Hz
Power consumption 14 W
430 × 120 × 385 mm
Dimensions (approx.)
(17 × 4 3/4 × 15 1/4 in.) incl. projecting
(w/h/d)
parts
Mass (approx.)
5.6 kg (12 lbs 6 oz)
Supplied accessories
Audio cord (2 phono plugs – 2 phono plugs) (1)
Remote commander (remote) (except for CDP-CE305 and
CDP-C661) (1)
Sony SUM-3 (NS) batteries (except for CDP-CE305 and
CDP-C661) (2)
Design and specifications are subject to change without notice.
Load
impedance
Over 10 kilohms
Wave length: 660nm
32 ohms
19
EN