MTD A4 Serie Manual De Instrucciones página 10

f
b. While stabilizing mower so it doesn't move, pivot
upper handle up as shown in Figure 3-2. Do not
crimp cable while lifting the handle up.
k. j
Figure 3-2
c. Reattach bolts and wing nuts removed earlier into
lower holes of handle as shown in Figure 3-2 inset.
2. Remove the T-bolts from the handle brackets as shown in
Figure 3-3.
3_
Follow the steps below to complete handle assembly:
a. Pull upward on the handle 8 inches until holes in
lower handle (shown in Figure 3-3 deck cutaway) line
up with holes in handle bracket. See Figure 3-4.
Figure 3-4
NOTE:When pulling upward on handle, make sure to not
pull handle all the way out.
b. Insert the T-bolts removed earlier through the
handle brackets and lower handle and tighten
securely to secure the handle in place. See Figure
3-4.
Figure 3-3
SECTION
3 -- ASSEMBLY &
SET-UP