Publicidad
Basics
Approximate values
Procedure
10
quicksharp
3.3
Power supply
The power supply plug should be attached to the connection cable by
an electrician in compliance with local regulations. Voltage is factory-
set by the manufacturer for the requirements in the country of
operation.
Check direction of rotation of the hydraulic pumps:
•
Remove enclosure (2)
•
Main switch (9) ON
•
Both pumps must rotate in direction of arrow (clockwise)
•
Pull the feed button (11) - the green indicator pin (8) must pop out
4.
Operation
Sharpen your tools regularly
Recommended regrinding amount: 0.1 - 0.2 mm
The approximate values below serve as an aid for correct setting:
∅ (mm)/Size
Scale value
* not Whispertools
4.1
Regrinding dies
Regrinding dies
•
Insert die in a suitable adapter ring.
•
Lock die in adapter ring onto the rotary tool holder with the
clamping jaws (loosen hex. screw on jaws and tighten)
*
Punch
30
76
1-2
2-3
Die
I
II
2-3
3-4
Fig. 9892
B60E
Publicidad
Capítulos
