Publicidad
Procedure
4
5
12
quicksharp
4.2
Regrinding flat punches
Regrinding flat punches
•
Insert punch (with alignment ring) into the punch grinding fixture
•
Tighten screws (1, 2 and 5)
•
Loosen screw (4)
•
Position slide (3) with red marker to the scale section for flat
punches (3):
1
2
3
Sine rule
•
Tighten screw (4)
•
Swing the locating stop (4) to the left; a certain amount of
resistance must be overcome when doing so. Raise the top (2).
•
Lock the punch grinding fixture on the rotary tool holder (3) with the
clamping jaws (loosen hex. screw on jaws and tighten)
•
Lower the top until the locating stop rests on the punch - then
swing the stop back to the right
•
Close flap (6); the machine cannot be started with the flap open
•
Set the desired regrind amount at the rotary knob (7)
•
Main switch (9) ON
•
First pull, then press the feed button (11)
•
Grinding takes place automatically. The quicksharp switches off
automatically when the grinding process is finished.
1
2
3
4 0
5 0
6 0
7 0
8 0
1 0 0
4
Fig. 9893
Fig. 9894
B60E
Publicidad
Capítulos
