General; Cutting Cover; Engine Brake Handle; Machine´s Safety Equipment - Husqvarna LC 140 Manual De Instrucciones

Ocultar thumbs Ver también para LC 140:
Tabla de contenido

Publicidad

General

This section describes the machine´s safety equipment,
its purpose, and how checks and maintenance should be
carried out to ensure that it operates correctly.
WARNING! Never use a machine that has
!
faulty safety equipment! If your machine
fails any checks contact your service
agent to get it repaired.
Prevent unintentional starting by
removing the ignition cable from the
spark plug.

Cutting cover

The cutting cover is designed to reduce vibration and
to reduce the risk of cuts.
Checking the cutting cover
Make sure the cutting cover is not damaged and that
there are no visible defects such as cracks.

Engine brake handle

The engine brake is designed to stop the engine.
When the grip on the engine brake handle is released
the engine should stop.
Inspecting the engine brake handle
Apply full throttle and then release the brake handle.
The engine should stop and the drive should
disengage. The engine brake should always be
adjusted so that the engine stops within 3 seconds.
Contact an authorised service workshop.
6 – English
MACHINE´S SAFETY EQUIPMENT
Muffler
WARNING! Never use a machine without
!
a muffler, or with a faulty muffler. A
damaged muffler may substantially
increase the noise level and the fire
hazard. Keep fire fighting equipment
handy.
The muffler gets very hot during and
after use. This also applies during idling.
Be aware of the fire hazard, especially
when working near flammable
substances and/or vapours.
The muffler is designed to keep noise levels to a
minimum and to direct exhaust fumes away from the
user.
Inspecting the muffler
Check regularly that the muffler is complete and
secured correctly.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Lc 140s

Tabla de contenido