Descargar Imprimir esta página

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 130
> Before Start
> Part Names
0 This setting cannot be selected when you have set "Configuration" - "Subwoofer" to "No".
∫ 3. Distance
Set the distance from each speaker to the listening position.
Front Left
Specify the distance between each speaker and the listening
position. (Default Value is "12.0 ft/3.60 m")
Front Right
Specify the distance between each speaker and the listening
position. (Default Value is "12.0 ft/3.60 m")
Subwoofer
Specify the distance between each speaker and the listening
position. (Default Value is "12.0 ft/3.60 m")
0 Default values vary depending on the regions.
0 Distance units can be switched by pressing CAPS on the remote controller. When the unit
is set as feet, you can set between 0.1 ft and 30.0 ft in increments of 0.1 ft. When the unit
is set as meters, you can set between 0.03 m and 9.00 m in increments of 0.03 m.
∫ 4. Level Calibration
Front Left
Select a value between "-12.0 dB" and "+12.0 dB" (in 0.5 dB
increments). A test tone will be output each time you change the
value. Select the desired level. (Default Value is "0.0 dB")
Front Right
Select a value between "-12.0 dB" and "+12.0 dB" (in 0.5 dB
increments). A test tone will be output each time you change the
value. Select the desired level. (Default Value is "0.0 dB")
Subwoofer
Select a value between "-15.0 dB" and "+12.0 dB" (in 0.5 dB
increments). A test tone will be output each time you change the
value. Select the desired level. (Default Value is "0.0 dB")

3. Audio Adjust

∫ 1. Volume
Mute Level
Set the volume lowered from the listening volume when muting
is on. Select a value from "-¶dB (default value)", "-40dB", and "-
20dB".
38
> Install
> Initial Setup
> Playback
Advanced Setup
Maximum Volume
Set the maximum value to avoid too high volume. Select "Off
(default value)" or a value between "50" to "99".
Power On Volume
Set the volume level of when the power is turned on. Select
"Last (default value)" (volume level before entering standby
mode), "Min", "0.5" to "99.5" and "Max".
0 You cannot set a higher value than that of "Maximum
Volume".
Headphone Level
Adjust the output level of the headphones. Select from "-
12.0 dB" to "+12.0 dB". (Default Value is "0.0 dB")
4. Source
∫ 1. IntelliVolume
Adjust the volume level difference between the devices connected to the unit. Select the
input selector to configure.
IntelliVolume
Select from "-12.0 dB" to "+12.0 dB". Set a negative (j) value if
the volume of the target device is larger than the others and a
positive (i) value if smaller. To check the audio, start playback of
the connected device. (Default Value is "0.0 dB")
0 This function is not effective in ZONE 2.
∫ 2. Name Edit
Set an easy name to each input. The set name will be shown on the main unit display. Select
the input selector to configure.
| Supplementary Information | Others

Publicidad

Solución de problemas

loading