Maintenance; Changing The Battery; Cleaning; Metrological Check - PCE CHAUVIN ARNOUX K 1 Manual De Instrucciones

!
For maintenance, use only specified spare parts. The manufacturer will not
be held responsible for any accident occuring following a repair done other
than by its after sales service or approved repairers.

5.1. CHANGING THE BATTERY

When the probe is in the "On" position, if the green "ON" indicator is out, it means that the
battery is dead. To change it proceed as follows :
Completely disconnect the probe from the circuit to measure and the measurement
instrument it is connected to.
Undo the screws holding the base of the case in place.
Change the 9 V battery (type 6LF22, 6LR61 or NEDA 1604).
Put the base of the case back in place and retighten the screws.
5.2. ENTRETIEN
!
The probe must not enclose a cable and must be disconnected from the
measurement instrument. Never run water on the probe.
Keep the jaw faces perfectly clean
Cleaning the body of the probe, the case and the lead with a damp cloth moistened
with soapy water.
Rinsing is also done with a damp cloth moistened with clear water.

5.3. METROLOGICAL CHECK

!
It is essential that all measuring instruments are regularly calibrated.
For checking and calibration of your instrument, please contact our accredited laboratories
(list on request) or the Chauvin Arnoux subsidiary or Agent in your country.
Our guarantee is applicable for twelve months after the date on which the equipment
is made available (extract from our General Conditions of Sale, available on request).
Repair under warranty or out of warranty
For any operation under warranty or out of warranty, please return the product to your
distributor.

5. MAINTENANCE

6. WARRANTY

19