Adjusting The Gas Pressure - Avanti CB350S Manual De Instrucciones

•
Connect the hose by inserting it into the hose outlet (to check that the hose is correctly
connected, try to remove it by slightly pulling it. Resistance indicates that the hose is correctly
connected. In order to disconnect the hose, push in the blue plastic collar on the hose outlet
while pulling the hose). See below.
•
Place the face of the regulator into the opening on the door and hold it in place with the latch
provided.
•
Close the door.
b) 255 gram (9 oz) cylinder (Accessory item, sold separately)
•
A 255 gram (9 oz) cylinder can be ordered and will dispense up to ten 5L kegs.
•
Make sure that the pressure gauge valve is shut (to shut the valve, turn it
counterclockwise).
•
Screw the gas cartridge on the pressure gauge until fit is tight and firm.
•
Connect the hose by inserting it into the regulator hose outlet (to check that the hose is
correctly connected, try to remove it by slightly pulling it. Resistance indicates that the hose is
correctly connected. In order to disconnect the hose, push in the blue plastic collar on the
hose outlet while pulling the hose). See below.
•
Place the assembly into the housing provided, making sure that the pressure gauge dial is in
front of the window and close the latch.
•
Close the door.

Adjusting the gas pressure

Beer type
German beers
French beers
Very fermented brown ales
CO2 content in %
+/- 0.5
+/- 0.6 à 0.8
+/- 0.6 à 0.8
12
Pressure in bar approx. 5°C
+/- 0.4 à 0.5 bars
+/- 0.8 bars
+/- 0.8 à 1 bars