Hints For Best Vacuuming Performance - ALFA roll 7941 Manual De Instrucciones

24 EN
4.

HINTS FOR BEST VACUUMING PERFORMANCE

1. Do not put too much stuff inside the bag: leave enough empty length in the open
end of the bag so that the bag can be placed on the vacuuming chamber more
positively.
2. Do not wet the open end of the bag. Wet bag may be difficult to melt.
3. There are many non-foods able to be vacuum packed. Keep camping supplies such
as matches, first aid kits and clothing clean and dry. Keep flares for auto emergen-
cies ready. Keep silver and collectibles untarnished.
4.
Clean and straighten the open end of the bag before sealing the bag. Make sure
nothing is left on the open area of the bag, no wrinkle or creased lines appeared on
the open panels.
5. Do not leave too much air inside the bag. Press the bag to allow extra air to escape
from the bag before vacuuming it. Too much air inside the bag increases the va-
cuum pump loading and may cause the motor insufficient power to draw away all
the air inside the bag!
6.
Do not vacuum packaging objects with sharp points like fish bones and hard shells!
Sharp points may penetrate and tear the bag!
7.
Suggest to vacuum seal one bag within 1 minute, to let the appliance resume
enough.
8. If it's not reach the required vacuum for some unknowable reason, the vacuum
system will shut automatically after 45seconds, in this situation, please check if the
bag is leak, or not placed properly or any other reasons.
9. During bag vacuum packaging process, small amounts of liquids, crumbs or food
particles can be inadvertently pull into removable interface, clogging the pump and
damaging your appliance.
10.
To avoid overfilling, always leave at least 6cm of bag material between bag contents
and top of bag. Then leave at least one additional inch of bag material for each time
you plan to reuse bag.
11. Pre-freeze fruits and blanch vegetables before vacuum packaging for best results.
·
To avoid possible illness, do not reuse bag after storing raw meats, fish or greasy
foods.
·
After finished the vacuum work, please always let the machine cover open, don't
fasten the cover, it will affect the machine function.