Cleaning And Maintenance; Troubleshooting - ALFA roll 7941 Manual De Instrucciones

28 EN
7.

CLEANING AND MAINTENANCE

System of Vacuum Preservation
1. Always unplug the unit before cleaning.
2. Do not immerse in water or any other liquid.
3. Do not use abrasive cleaners to clean the unit, for they will scratch the surface.
4. Wipe the outside of the unit with a damp cloth or sponge and mild dish soap.
5.
To clean the inside of the unit, wipe away any food or liquid with a paper towel.
6.
Dry thoroughly before using again.
7.
Wipe away food residue and water inside or around component with a paper
towel.
The airproof loop of sponge should be dried thoroughly before re-assembling, when
re-assembling, be careful to prevent any damage, and assemble as original position
to ensure no vacuum leaking.
8.

TROUBLESHOOTING

Nothing happens when press the vacuum sealer
1.
Make sure the power cord is correctly plugged into the electrical outlet, and in "on"
position. Test electrical outlet by plugging in another appliance, if it not workable,
please check the circuit breakers or fuses in your home.
2. Check power cord and plug, and make sure they are not damaged in any way. If
damaged, do not use the vacuum sealer.
Air is not removed from the bag completely
1. To seal properly, open end of bag should be resting entirely inside vacuum chamber
area.
2.
Check sealing strip and gasket beneath the lid for debris and position. Wipe clean
and smooth them back into place.
3.
Bag may have a hole. To test, seal the bag with some air in it, submerge in water,
and apply pressure. If there are bubbles present, it does indicate a leak and a new
bag should be used.
4. To check if lid is completely latched into place.