Epson TM-U220 Manual Del Usuario página 14

English
If you are going to store the printer or leave it unused for a long time, turn it
off using the power supply switch on the printer.
Inserting and Replacing the Ribbon Cassette
The print head becomes very hot during printing. Allow it to cool before you replace the
ribbon cassette.
CAUTION:
Never turn the ribbon cassette's feed knob in the opposite direction of the arrow marked on
the cassette; otherwise the ribbon cassette may be damaged.
Note:
Use the EPSON ERC-38 ribbon cassette for your printer.
1. Open the ribbon cassette cover by using the tabs on the sides of the cover,
as shown in illustration
2. Turn the knob two or three times in the direction of the arrow, as shown
in illustration E.
3. Insert the ribbon in the position shown in illustration F and push the
ribbon cassette down until it clicks.
Note:
Make sure the ribbon is installed between the print head and the platen
without wrinkles or creases.
4. Again turn the ribbon cassette's knob 2 or 3 times in the direction of the
arrow and close the ribbon cassette cover.
Be careful not to touch the print head with your fingers when turning the ribbon
cassette knob because the print head is hot and you might be burned.
When you replace the ribbon casette, lift the left side of the ribbon cassette
first; then lift the whole ribbon cassette.
Inserting Roll Paper
CAUTION:
Be sure to use roll paper that meets the specifications.
Be sure not to touch the manual cutter. Otherwise your fingers might be injured.
6 TM-U220 User's Manual
CAUTION:
D
CAUTION:
.