Use Of The Machine; Description Of The Controls - Merand AQUAPAN 75 Manual De Instrucciones

24.

USE OF THE MACHINE

24.1.

DESCRIPTION OF THE CONTROLS

For the tension of the machine it is necessary to press the principal switch "A"
placed in the lateral part of the machine.
The controls of the machine will be done from the dashboard of the controls
on the side of the machine.
The controls are the following:
F
B
D
C
B Emergency switch:
provokes the emergency stop of the machine. For
starting the machine back again its necessary to knock out of its position and
press again the button to start.
C Switch for reset: it's to reset the machine after a stop .
D Switch of start/stop:
to put on or off the machine. As well there is
installed a button of on/off at the end of the band at the exit, to help the
recollection of the product.
E Guillotine switch:
located al the side of the exit door of the machine. It is
used for starting the counter of the length of cut of the guillotine. When you
press the guillotine switch, it does a cut and its starts to count the length
specified on the length cut parameter
F Programming console:
Access to introduce and modify the parameters
and the speed for the different types of products that the machine can do and
to start the different groups of the machine.
Page 53
H.BERDER 10/04/2012